Infrasonic Alarm  (490-0825)        Operation           Faxback Doc. # 8883

SETTING THE ALARM RECEIVER'S SENSITIVITY

The alarm receiver has three levels of sensitivity-HIGH, MED, and LOW.  We
recommend that you set the HIGH/MED/LOW switch to MED at first.  This
prevents false alarms if your vehicle is exposed to strong gusts of wind.

ARMING THE ALARM SYSTEM

You can arm the alarm system from outside the vehicle.  After you turn off
the vehicle's ignition, close all windows and lock the passenger doors.
Follow these steps to arm the alarm system.

1.  Press and hold down the right button on the transmitter for about 2
    seconds.  The alarm's receiver chirps twice.

Note:  Each time you press a button, the transmitter's indicator lights.

2.  Press the left button twice and the right button once within 4 seconds.
    The receiver chirps twice and 16 beeps sound for about 21 seconds as an
    exit delay if you are still inside the car.  When the beeping stops,
    the alarm system's is armed, and the receiver's ARMED indicator light.

Note:  If the alarm receiver fails to chirp or beep, repeat the arming
       procedure.


SILENCING THE ALARM

If the alarm is activated, the alarm receiver sounds for about 1 minute and
15 seconds.

You can silence the alarm before it automatically stops by pressing and
holding down either button on the transmitter for about 2 seconds.  Three
beeps sound when the system disarms.  Follow the procedure under "Arming
the Alarm System" to arm the system again.

DISARMING THE ALARM SYSTEM

Press and hold down either button on the transmitter for about 2 seconds.
The receiver chirps once when it disarms.

Note:  If the receiver chirps three times, the alarm was activated while
       you were away.

(SMC/jlc-03/22/94)