Pocket Vision-30  (160-0167)         Operation          Faxback Doc. # 7902

USING YOUR TV

1.  Extend the rod antenna.

2.  Set VHF/UHF to VHF or UHF.

3.  Turn OFF/PICTURE OFF/TV to TV.  The TV starts scanning and stops at
    the next active channel in the selected band.

4.  Press TUNING < or > to tune to a different channel.  The tuning line
    on the screen aligns with the selected channel number below the
    screen.

5.  Adjust VOLUME.

6.  Adjust the antenna for the best reception.

7.  Adjust BRIGHT for the desired brightness.  The brightness also changes
    with the screen's angle.

NOTES:  Press CH CALL (Channel Call key) to verify which channel the TV is
        tuned to.  The tuning indicator (a green vertical line) will
        appear above the approximate channel number on the channel
        display.

        If reception is poor, adjust the length or angle of the rod
        antenna.  If you are inside a metal or concrete building, moving
        closer to a window might improve reception.

USING PICTURE OFF

You can listen to the TV sound by setting the power switch to the PICTURE
OFF position.  In this position, the display is turned off and the tuning
indicator does not display.

NOTE:  Adjust the TV's position for the best reception on the selected
       channel before setting the power switch to the PICTURE OFF
       position.

USING THE TV AS A MONITOR

You can connect an audio/video component to the TV's A/V IN jack.  This
requires a special cable (not supplied), available through your local
Radio Shack store by special order (CMC 16-2324).

NOTE:  Do not use standard audio patch cords for this connection.  The
       audio and video signals will be distorted.

To use the cable, connect its yellow plug to the audio/video component's
video output jack and its white plug to the component's audio output jack. 
Then, plug the cable's sub-mini plug into the TV's A/V IN input jack.

NOTE:  The TV cannot receive antenna signals when the cable is connected
       to the TV's A/V IN jack.

BACKLIGHT

In low temperatures, the TV screen takes a few seconds to light, or it
might be slightly red in color.  This is not a malfunction.  Normal
operation resumes after a short while.

USING AN EARPHONE

For quiet listening, connect an optional earphone with a 1/8-inch plug to
the EAR jack.

CAUTIONS:  Set VOLUME to the lowest setting before you begin listening. 
           Then, adjust the volume to a comfortable level.

           Do not wear the earphone while operating a motor vehicle or
           riding a bicycle.  This can cause a traffic hazard and is
           illegal in some areas.

(ALL-10/21/94)