DMP 206  (260-2906)           Hints and Tips           Faxback Doc. # 5865

If the printer fails to operate properly, carefully check all connections.
Then, try to correct the problem by using the following troubleshooting
hints.  If you still have problems, contact your local Radio Shack store
for assistance.

SYMPTOM                    CAUSE                      REMEDY

The printer does not      Power is not getting to    Be sure the power cord
print and the POWER       the printer.               is securely connected
indicator does not light                             and POWER is set to ON


The printer does not      The printer is off line.  Press ON/OFF LINE to
print but the POWER                                 set the printer on line
indicator does light      The connection to the     Be sure to load the
                          computer is not           paper.
                          secured.                  Be sure you securely
                                                    the cable to the print-
                                                    er and the computer.
                          The ribbon cartridge is   
                          not correctly installed   Install the ribbon
                                                    cartridge correctly


The printer operates     The paper is jammed in     Remove the paper and
correctly, but the       the printer, or it is      reinsert it correctly
paper does not feed      not properly loaded.       See "LOADING Paper."
properly.  The POWER
indicator flashes.


GENERAL:

-When you turn off the DMP 206, the printer loses all data stored in its
 buffer.  Keep this in mind as you do routine maintenance.  Remember that
 toggling the printer's power switch can also cause erratic operation.

-Always insert paper before you operate the printer.  Be careful not to
 print past the paper edge.

-When printouts are too light or too dark, check to see if you correctly
 set the head position lever.

-Graphics printing places a heavier load on the print head than printing
 test characters.

When you must print graphics continuously, be sure to pause the printing
for at least a few minutes after printing about 50 lines.  This lets the
print head cool and prevents damage to the print head.

-Place the printer on a stable surface to prevent excessive vibration
 during operation.

(smc-10/04/93)