Power Switching System  (260-0203)    Setup            Faxback Doc. # 2802

The System is designed so that you can install it between your computer
system and monitor for easy access, or use it as a base for the monitor.
When the monitor is mounted on the System, you can easily adjust the
viewing angle since the monitor rotates when the System is turned on its
swivel base.

Place the Power Switching System on a sturdy, level surface.

Check that airflow is not impeded by carpet on the floor or any material
which could block either the side or the bottom vents.

1.  Plug the equipment of your computer system into the designated outlets
    on the System.  Do not exceed the rated capacity of each outlet.  Be
    sure that all panel switches are in the OFF position.

2.  Plug the System's AC cord into an AC outlet.

3.  Set the MASTER switch to the ON position.  Then press the outlet
    switch for the equipment you wish to use.

Once the System is set up, two methods can be used for controlling power
to it.

Set all the switches on the System's front panel to the ON position, then
use the MASTER switch to simultaneously turn on (or off) the equipment.

Set the MASTER switch to ON, then turn on (or off) each device be using
the front panel outlet switch.

(ALL-8/29/94)