Current updates!
===============

uGophy!
======

I'm already build versions for ZX-Uno, Original Speccies with
ESP on AY chip(versions for esxDOS, +3DOS including +3e and
jsut tape version). 

Now I'm merging all version in single source tree and
preparing conditional builds to make development process
easier.

When I'll make it - version 1.0 will be published.

I don't think that it gets some major improvments but it will
be first version that will be available for almost every 128k
speccy.

What about port for Spectrum Next and MB03+?
============================================

There some minor issues. COVID breaks postal communication
between EU and Russia - so I can't get gifted SpecNext 
for debugging.

I've made some version in "blind" mode but it works a bit
unstable. Some folks can run it, some - not. So debug hardware
issues without hardware isn't easy task.

MB03+ can't be shipped to me by same reason.

COVID breaked too much plans.

My +UNO is dead
===============

My main ZX Spectrum clone +UNO was dead.

My cat throwed it from table to floor and board have some 
microbreaks now.

I've tried repair it but it still have some video output 
issues. But now it even starts and usually shows video output
(but not clear and not always). 

I still have just ZX-Uno v.4.2 but it was my favorite
speccy.

Other projects:
==============

GUI-based network manager:
 - Already works on +3 with ESP on AY and will be ported
to esxDOS and ZX-Uno's uart too

Two way file exchange(PC<->Speccy via network):
 - I've sent first file from speccy to PC, but application 
need to be rewritten cause I've made some mistakes at start
point. Sorry, it will be made, but just later.

Slice of life
=============

I'm overloaded on my job now and falled into depression.

Our company(where I'm employed) have serious issues cause 
COVID. My perfomance on all pet project will be really 
down. 
 
My company unemployed 30% of staff. So I need save my place.

Sorry, if someone waits quick releases - it isn't easy for 
me.