Network Working Group B. Thomas
Request for Comments: 3037 Cisco Systems, Inc.
Category: Informational E. Gray
Zaffire, Inc.
January 2001
LDP Applicability
Status of this Memo
This memo provides information for the Internet community. It does
not specify an Internet standard of any kind. Distribution of this
memo is unlimited.
Copyright Notice
Copyright (C) The Internet Society (2001). All Rights Reserved.
Abstract
Multiprotocol Label Switching (MPLS) is a method for forwarding
packets that uses short, fixed-length values carried by packets,
called labels, to determine packet nexthops. A fundamental concept
in MPLS is that two Label Switching Routers (LSRs) must agree on the
meaning of the labels used to forward traffic between and through
them. This common understanding is achieved by using a set of
procedures, called a label distribution protocol, by which one LSR
informs another of label bindings it has made. This document
describes the applicability of a set of such procedures called LDP
(for Label Distribution Protocol) by which LSRs distribute labels to
support MPLS forwarding along normally routed paths.
1. LDP Applicability
A label distribution protocol is a set of procedures by which one
Label Switching Router (LSR) informs another of the meaning of labels
used to forward traffic between and through them.
The MPLS architecture allows for the possibility of more than a
single method for distributing labels, and a number of different
label distribution protocols are being standardized. Existing
protocols have been extended so that label distribution can be
piggybacked on them, and new protocols have been defined for the
explicit purpose of distributing labels.
Thomas & Gray Informational [Page 1]
RFC 3037 LDP Applicability January 2001
This document describes the applicability of the Label Distribution
Protocol (LDP), a new protocol for label distribution designed to
support label distribution for MPLS forwarding along normally routed
paths as determined by destination-based routing protocols. This is
sometimes called MPLS hop-by-hop forwarding.
LDP, together with an IP routing plane and software to program ATM
switch or Frame Relay switch cross-connect tables, can implement IP
in a network of ATM and/or Frame Relay switches without requiring an
overlay or the use of ATM-specific or Frame Relay-specific addressing
or routing.
LDP is also useful in situations that require efficient hop-by-hop
routed tunnels, such as MPLS-based VPN architectures [RFC2574] and
tunneling between BGP border routers.
In addition, LDP includes a mechanism that makes it possible to
extend it to support MPLS features that go beyond best effort hop-
by-hop forwarding.
As a stand-alone protocol for distributing labels LDP does not rely
on the presence of specific routing protocols at every hop along an
LSP path in order to establish an LSP. Hence LDP is useful in
situations in which an LSP must traverse nodes which may not all
support a common piggybacked approach to distributing labels.
Traffic Engineering [TE] is expected to be an important MPLS
application. MPLS support for Traffic Engineering uses explicitly
routed LSPs, which need not follow normally-routed (hop-by-hop)
paths.
Explicitly routed LSPs may be setup by CR-LDP [CRLDP-AS], a set of
extensions to LDP, or by RSVP-TE [RSVP-TE-AS], a set of extensions to
RSVP. There is currently no consensus on which of these protocols is
technically superior. Therefore, network administrators should make
a choice between the two based upon their needs and particular
situation.
2. Requirement Level
The "requirement level" [RFC2026] for LDP is:
Implementation of LDP is recommended for devices that perform MPLS
forwarding along normally routed paths as determined by
destination-based routing protocols.
Thomas & Gray Informational [Page 2]
RFC 3037 LDP Applicability January 2001
3. Feature Overview
LDP associates a Forwarding Equivalence Class (FEC) [RFC3031] with
each label it distributes. Two LSRs which use LDP to exchange FEC-
label binding information are known as "LDP Peers", and we speak of
there being an "LDP Session" between them.
LDP uses TCP for session communication. Use of TCP ensures that
session messages are reliably delivered, and that distributed labels
and state information associated with LSPs need not be refreshed
periodically.
LDP includes a mechanism by which an LSR can discover potential LDP
peers. The discovery mechanism makes it unnecessary for operators to
explicitly configure each LSR with its LDP peers.
When an LSR discovers another LSR it follows the LDP session setup
procedure to establish an LDP session. By means of this procedure
the LSRs establish a session TCP connection and use it to negotiate
parameters for the session, such as the label distribution method to
be used (see below). After the LSRs agree on the parameters, the
session is operational and the LSRs use the TCP connection for label
distribution.
LDP supports two different methods for label distribution. An LSR
using Downstream Unsolicited distribution advertises FEC-label
bindings to its peers when it is ready to forward packets in the FEC
by means of MPLS. An LSR using Downstream on Demand distribution
provides FEC-label bindings to a peer in response to specific
requests from the peer for a label for the FEC.
LDP allows LSRs flexibility in strategies for retaining learned
labels. An LSR using liberal label retention stores all labels
learned from peers regardless of whether it currently needs them for
forwarding, whereas one using conservative label retention stores
only labels for which it has immediate use and releases unneeded
labels to the peer that advertised them.
In addition, LDP allows flexibility in strategies for when to
advertise FEC-label bindings. An LSR using independent control mode
advertises FEC-label bindings to peers whenever it sees fit, whereas
one using ordered control advertises bindings only when it has
previously received a label for the FEC from the FEC nexthop or it is
an MPLS egress for the FEC.
Downstream on Demand distribution with conservative label retention
and ordered control is appropriate in situations where labels are a
relatively scarce resource that must be conserved, and Downstream
Thomas & Gray Informational [Page 3]
RFC 3037 LDP Applicability January 2001
Unsolicited distribution with liberal label retention and independent
control is appropriate where labels are plentiful and need not be
carefully conserved. However, the protocol permits other
combinations of distribution method, label retention mode and control
mode, including hybrid variants of them.
LDP defines a mechanism for loop detection to protect against
forwarding loops in LSPs that traverse non-TTL MPLS clouds; see
[RFC3031] for discussion of situations which may benefit from this
mechanism. The loop detection mechanism is optional in the sense
that it may be disabled by LSR configuration. However, an LDP-
compliant LSR must implement it.
LDP includes an extension mechanism which supports the development of
vendor-private and experimental features. This mechanism defines
procedures for introducing new types of messages and TLVs, methods an
LSR can use for detecting such messages and TLVs, and procedures an
LSR must follow when it receives a message or TLV it does not
implement. While it is not possible to make every future enhancement
backwards compatible, these procedures facilitate the introduction of
new capabilities in MPLS networks that include older implementations
that do not recognize them.
4. Scalability Considerations
The following factors may influence the scalability of LDP
implementations:
- LDP label distribution is incremental, requiring no periodic
refresh of FEC-label bindings.
- In situations were label resources may be scarce (ATM and Frame
Relay links) the use of the Downstream on Demand distribution
method with conservative label retention ensures that only
those labels required to support normally-routed paths are
allocated and distributed.
- In situations where label resources are not scarce, the use of
the Downstream Unsolicited method with liberal label retention
ensures that changes in FEC nexthop from one LDP peer to
another require no distribution action to update previously
distributed labels.
- Limitations on the number of TCP connections an LSR supports
limit the number of LDP peers the LSR can support.
Thomas & Gray Informational [Page 4]
RFC 3037 LDP Applicability January 2001
- Use of the optional path vector based loop detection mechanism
imposes additional memory and processing requirements on an
LSR, as well as additional LDP traffic. Both impact
scalability.
5. Security Considerations
LDP defines the optional use of the TCP MD5 Signature Option to
protect against the introduction of spoofed TCP segments into LDP
session connection streams. LDP use of the TCP MD5 Signature Option
is similar to BGP [RFC1771] use of the option specified in [RFC2385].
6. References
[CRLDP-AS] J. Ash, M. Girish, E. Gray, B. Jamoussi, G. Wright,
"Applicability Statement for CR-LDP", Work in Progress,
September 1999.
[RFC1771] Rekhter, Y. and T. Li, "A Border Gateway Protocol 4
(BGP-4)", RFC 1771, March 1995.
[RFC2026] Bradner, S., "The Internet Standards Process -- Revision
3", BCP 9, RFC 2026, October 1996.
[RFC2385] Heffernan, A., "Protection of BGP Sessions via the TCP
MD5 Signature Option", RFC 2385, August 1998.
[RFC2547] Rosen, E. and Y. Rekhter, "BGP/MPLS VPNs", RFC 2547,
March 1999.
[RFC3036] Andersson, L., Doolan, P., Feldman, N., Fredette, A. and
B. Thomas, "LDP Specification", RFC 3036, January 2001.
[RFC3031] Rosen, E., Viswanathan, A. and R. Callon, "Multiprotocol
Label Switching Architecture", RFC 3031, January 2001.
[RSVP-TE-AS] Awduche, D., Hannan, A. and X. Xiao, "Applicability
State for Extensions to RSVP for LSP-Tunnels", Work in
Progress, April 2000.
Thomas & Gray Informational [Page 5]
RFC 3037 LDP Applicability January 2001
7. Authors' Addresses
Eric Gray
Zaffire, Inc
2630 Orchard Parkway,
San Jose, CA 95134-2020
Phone: 408-894-7362
EMail: ewgray@mindspring.com
Bob Thomas
Cisco Systems, Inc.
250 Apollo Dr.
Chelmsford, MA 01824
Phone: 978-244-8078
EMail: rhthomas@cisco.com
Thomas & Gray Informational [Page 6]
RFC 3037 LDP Applicability January 2001
8. Full Copyright Statement
Copyright (C) The Internet Society (2001). All Rights Reserved.
This document and translations of it may be copied and furnished to
others, and derivative works that comment on or otherwise explain it
or assist in its implementation may be prepared, copied, published
and distributed, in whole or in part, without restriction of any
kind, provided that the above copyright notice and this paragraph are
included on all such copies and derivative works. However, this
document itself may not be modified in any way, such as by removing
the copyright notice or references to the Internet Society or other
Internet organizations, except as needed for the purpose of
developing Internet standards in which case the procedures for
copyrights defined in the Internet Standards process must be
followed, or as required to translate it into languages other than
English.
The limited permissions granted above are perpetual and will not be
revoked by the Internet Society or its successors or assigns.
This document and the information contained herein is provided on an
"AS IS" basis and THE INTERNET SOCIETY AND THE INTERNET ENGINEERING
TASK FORCE DISCLAIMS ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING
BUT NOT LIMITED TO ANY WARRANTY THAT THE USE OF THE INFORMATION
HEREIN WILL NOT INFRINGE ANY RIGHTS OR ANY IMPLIED WARRANTIES OF
MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.
Acknowledgement
Funding for the RFC Editor function is currently provided by the
Internet Society.
Thomas & Gray Informational [Page 7]