ZERO GRAVITY TOILET

PASSENGERS ARE ADVISED TO READ INSTRUCTIONS BEFORE USE

1   This toilet is of the standard zero-gravity type. Depending on
    requirements, system A and/or system B can be used, details of which are
    clearly marked in the toilet compartment. When operating system A, depress
    lever and a plastic dalkron eliminator will be dispensed through the slot
    immediately underneath. When you have fastened the adhesive lip, attach
    connection marked by the large "X" outlet hose. Twist the silver coloured
    ring one inch below the connection point until you feel it lock.

2   The toilet is now ready for use. The Sonovac cleanser is activated by the
    small switch on the lip. When securing, twist the ring back to its
    initial-condition, so that the two orange lines meet. Disconnect. Place the
    dalkron eliminator in the vacuum receptacle to the rear. Activate by
    pressing the blue button.

3   The controls for system B are located on the opposite wall. The red
    release switch places the uroliminator into position; it can be adjusted
    manually up or down by pressing the blue manual release button. The opening
    is self-adjusting. To secure after use, press the green button which
    simultaneously activates the evaporator and returns the uroliminator to its
    storage position.

4   You may leave the lavatory if the green exit light is on over the door.
    If the red light is illuminated, one of the lavatory facilities is not
    properly secured. Press the "Stewardess" call button to the right of the
    door. She will secure all facilities from her control panel outside. When
    green exit light goes on you may open the door and leave. Please close door
    behind you.